MAINTENANCE
• After each use, blow air through the multi-function sharpener housing to
ensure it is free from all dust particles which may build up. Build up of dust
particles may cause the multi-function sharpener to overheat and fail.
• If the enclosure of the multi-function sharpener requires cleaning, do not use
solvents but a moist soft cloth only. Never let any liquid get inside the multi-
function sharpener; never immerse any part of the multi-function sharpener
into a liquid.
DESCRIPTION OF SYMBOLS
Regulator compliance mark
Read instruction manual
CARING FOR THE ENVIRONMENT
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your
local council authority for recycling advice.
Wear eye protection
TROUBLESHOOTING
Sparking visible through the housing air vents
A small amount of sparking may be visible through the housing vents.
This is normal and does not indicate a problem.
The tip of my drill bit is turning blue
This is because the drill bit is overheating. You will need to reduce the amount of
pressure and sharpening time, cool the drill bit in water in between sharpening.
One edge of my drill bit is longer than the other (the centre
point is therefore not centred)
One side of the drill bit has been sharpened for longer than the other. You will need
to sharpen the shorter side for more time and ensure that both sides are always
sharpened for the same amount of time using the same amount of pressure.
My drill bit is broken (rather than blunt)
The MFS-4000 is not suitable for sharpening broken drill bits. A drill bit in this
condition will take a substantial amount of time to sharpen. Rough the drill bit into
shape first using a bench grinder.
The multi-function sharpener does not start
Check that the accessory module is clicked into place to engage the safety switch.
SPARE PARTS
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: enquires@ozito.com.au
Need help?
Do you have a question about the MFS-4000 and is the answer not in the manual?
Questions and answers