Advertisement
Adjusting The Speed
The speed of the wrench should be adjusted to suit the size of the bolt/nut
being driven to avoid stripping or damaging the fastener.
1. Press the speed setting button
to cycle through the 3 speed
settings. The LED will light up to
indicate which setting the tool
is on.
2. Vary the amount of pressure
applied to the on/off trigger for
finer control of the speed.
Note: The speed setting control
will limit the maximum speed
reached when the trigger is
squeezed all the way in.
SLOWER
FASTER
OPERATION
4. USAGE
1. Squeeze and release the on/off
trigger to ensure it is not locked.
2. Check the forward/reverse lever
is on desired setting.
3. Adjust the speed setting to suit
the application.
Note: Always try fastening or loosening on the lowest speed setting first
before increasing it as required. This minimises the chance of damaging the
fastener with excessive torque.
4. Ensure the work piece is secured to stop it turning whilst driving.
5. Hold the socket firmly
against the bolt to stop
it slipping.
6. Slowly increase
pressure on the trigger
to appropriate torque for
circumstances until bolt
is tightened.
WARNING!
USE THE IMPACT WRENCH ONLY FOR
TIGHTENING AND LOOSENING SCREWS AND NUTS.
IF YOU WANT TO USE THE IMPACT WRENCH
TO TIGHTEN SCREWS AND NUTS TO A SPECIFIC
TORQUE, A TORQUE LIMITER MUST BE USED.
FORWARDS
REVERSE
PXBWS-400
Advertisement
