KNOW YOUR PRODUCT SETUP & PREPARATION MULTI FUNCTION TOOL 1. ASSEMBLY 1. Accessory Drive Spindle 4. Rear Handle 2. Side Handle 5. Variable Speed Dial Accessory Fitment 3. On/Off Switch 1. Place accessory over the drive spindle and position to suit angle needed for application.
OPERATION 2. CONTROLS 3. SANDING The tool is recommended for use with a residual current 1. Turn multi function tool 2. Place the multi function tool device with a rated residual current of 30mA or less. on and select appropriate flat on the workpiece.
Page 4
Grout Removal Disc 1. Turn the multi function tool on and select speed. 2. Use slight pendulum motion when cutting. Note: Periodicaly turn the unit off and remove any built-up dust and debris. MFR-2100...
Variable Speed Switch SPMFR2100-36 Note: Ozito Industries will not be responsible for any damage or injuries Side Handle SPMFR2100-509 caused by the repair of the multi function tool by an unauthorised person or by mishandling of the multi function tool.
Note: The supply of 230V and 240V on Ozito tools are interchangeable for Australia and New Zealand. Using an Extension Lead Always use an approved extension lead suitable for the power input of this tool.
• Failure to perform maintenance as set out within the instruction manual. • If the tool is disassembled or tampered with in any way. • Professional, industrial or high frequency use. OZITO 0913 Australia/New Zealand (Head Office) 1-23 Letcon Drive, Bangholme, Victoria, Australia 3175.