KNOW YOUR PRODUCT SETUP & PREPARATION 1. CHANGING THE BLADE JIGSAW 1. Guide Roller 5. Lock On Switch Ensure the tool is disconnected from the power supply before performing any of the following operations. 2. Variable Speed Dial 6. Soft Grip Handle 3.
OPERATION 2. ADJUSTING SHOE ANGLE 3. ON/OFF SWITCH The tool is recommended for use with a residual current The angle of the shoe can be adjusted to allow for bevel cuts device with a rated residual current of 30mA or less. between 0 and 45°.
4. Start the jigsaw. Allow it to reach maximum speed. 2. Pass the blade through the hole and begin the cut. Tip: Use light pressure when making curved cuts. 5. Place the base on to the workpiece and move forward with light pressure. JSW-4000...
Always replace both carbon brushes at the same time. Note: Ozito Industries will not be responsible for any damage or injuries caused by the repair of the jigsaw by an unauthorised person or by mishandling SPARE PARTS of the jigsaw.
Page 6
Tool: 400W Jigsaw SPARE PARTS Model No. JSW-4000 22 23 19 20 17 18 15 16 The following is a list of spare parts carried by Ozito. Please contact Customer Service for any parts not listed. Item Item Description Part No.
When using an extension lead on a reel, always unwind the lead completely. Use of an extension lead not Note: The supply of 230V and 240V on Ozito tools are interchangeable for Australia and New Zealand. suitable for the power input of the tool or which is damaged or defective may result in a risk of fire and electric shock.
• Failure to perform maintenance as set out within the instruction manual. • If the tool is disassembled or tampered with in any way. • Professional, industrial or high frequency use. OZITO Australia/New Zealand (Head Office) 1-23 Letcon Drive, Bangholme, Victoria, Australia 3175. 0812...
Need help?
Do you have a question about the JSW-4000 and is the answer not in the manual?
Questions and answers