Parameter Description - TECO speecon 7200ma Instruction Manual

■ Parameter description

The 7200MA has 4 groups of user parameters:
Parameters Description
An-□□
Bn-□□
Sn-□□
Cn-□□
The parameter setting of Sn-03 (operation status) will determine if the setting
value of different parameter groups are allowed to be changed or only to be
monitored, as shown below:
Sn-03
*1
0
1
*1：Factory setting
*2：When in DRIVE mode, the parameter group Sn-, Cn- can only be monitored if
the key and the
RESET
After a few trial and adjustment, the setting value Sn-03 is set to be "1" so as not
be modified again.
Frequency command
Parameter groups can be changed during running
System parameter groups (can be changes only after stop)
Control parameter groups (can be changed only after stop)
DRIVE mode
To be set
To be monitored
An,Bn
An Bn,(Sn,Cn)
DSPL
To be set
Sn,Cn An,Bn,Sn,Cn
*2
key are to be pressed simultaneously.
31
PRGM mode
To be monitored
An Bn,Sn,Cn
－