Display Contents In Drive Mode And Prgm Mode - TECO speecon 7200ma Instruction Manual

■ Display contents in DRIVE mode and PRGM mode

*1 When the inverter is powered up, the inverter system immediately enters into
DRIVE mode. Press the
If the fault occurs, press the
the corresponding Un-□□ contents. If a fault occurs in the DRIVE mode, the
corresponding fault will be displayed. Press the
*2 The monitored items will be displayed according to the settings of Bn-12 and Bn-13.
*3 When in the DRIVE mode, press the
values of Sn- and Cn-□□ will only be displayed for monitoring but not for
changing or setting.
PRGM mode
DSPL
An- □ □ monitor set
DSPL
Bn- □ □ monitor set
DSPL
Sn- □ □ monitor set
DSPL
Cn- □ □ monitor set
PRGM
DRIVE
PRGM
DRIVE
Power on
PRGM
DRIVE mode
DRIVE
Frequency reference
value displayed
display monitor set item
Un- □ □ monitor
An- □ □ monitor set
Bn- □ □ monitor set
DSPL
Sn- □ □ monitor
Cn- □ □ monitor
key, the system will switch into PRGM mode.
key and enter into DRIVE mode to monitor
RESET
key and
DSPL
30
*1
DSPL
DSPL
*2
DSPL
DSPL
DSPL
*3
+
DSPL
RESET
DSPL
key and reset the fault.
key, the setting
RESET