Led Display Setup - TECO E510s Series Instruction Manual

LED status description
Frequency / Line
speed Indicator
Menu mode
indicator
FWD indicator
REV indicator

4.1.3 LED display setup

On power up, digital display screens will be shown below.
User selectable display formats：
12- 00 Display mode
0
High
Each of the 5 digis can be set to any of the selections below from 0~8.
Range
【0】：Display display
【3】：DC voltage
【6】：AI1 input value
The highest bit of 12-00 sets the power on the display, other bits set the selected display from range
0-7, as the liste above.
LED indicator light status
ON while displaying frequency or linear speed
Hz/RPM
ON while not
displaying
frequency or line
FUN
speed
ON while running
forward
FWD
ON while running
reverse
REV
0 0 0 0
Low
【1】：Output current
【4】：Temperature
【7】：AI2 input value
LED indicator flashing status
FWD
REV
DSP/FUN
4-4
Flashing while fire
mode enabled
Flashing while
stopped in
Forward mode.
Flashing while
stopped in
Reverse mode
DSP/FUN
【2】：Output voltage
【5】：PID feedback
【8】：Counter Value