Omron NB3Q-TW_B Startup Manual page 98

8
When opening a project, what if there is a prompt: [Font not existing in the system]
For example: if attempting to open a project involving
, a prompt [
If this font issue is ignored,
UnBatang.
9
How to set the addresses of the component for displaying warnings and events, and how to
inquire warnings and events
It's best to use the internal register of the HMI - LW for the address type of the component for
displaying warnings and events, and the address can be designated as any of the vacant
address in the project. When we record warnings and events on HMI, one page is almost
certainly not enough, then turn-page inquiring is needed to be set, thus the address in the
attributes of the component for displaying warnings and events takes effect. Take LW10 for an
example, as follows:
NB-series Programmable Terminals Startup Guide Manual(V109)
6 Maintenance and Troubleshooting
does not exist] will pop up, as follows:
will be replaced with a font that exists in the system, eg.
in a PC that does not incorporate
6
6-9