Omron NB3Q-TW_B Startup Manual page 67

4 Screen Creation
User should use this method to create totally 7 frames for this project, the frames ID and names
are listed as below:
10
11
12
13
14
15
16
17
2
Double-click "Wait" window to eject [Window Attribute], select "User Background Color" and set
"Fill Color" to "lightCyan".
Bit State Setting Component
1
Bit State Setting component for switching to the maintenance screen
The Bit State Setting component on the upper left corner is used for switching to the
maintenance screen ([6 Check 1] screen).
Function: The ladder programs of CP1E will switch the screen to [6 Check 1] after pressing it to
set W0.02 to be ON. The Function Key is set transparent and will not function until being
pressed for 3 seconds for the purpose of avoiding being pressed accidentally.
Select [Bit State Setting component] from [PLC Parts], drag it to the design window after
selecting it with a single-click.
The attribute settings are:
Write Address
Bit State Setting Types
Graphics
Control Setting
(Security Setting)
4-14
Frame ID
Wait
Open
Close
Stop
Fully Open
Check1
Check2
Check3
W0.02
On
Use the vector graphic:
Dashed.vg (A vector graphic created by user,
which is a light cyan rectangle)
Minimum press time 3s
Frame Name
NB-series Programmable Terminals Startup Guide Manual(V109)