Omron NB3Q-TW_B Startup Manual page 87

5 Run
Note USB driver for NB7W must be installed in the PC if USB is used to connect NB7W and the PC. The USB
driver should be installed automatically when NB-Designer is run on a PC the first time. Please refer to 2-4
Installation of USB Driver for NB in the NB-Designer Operation Manual for details on the USB driver.
Using Ethernet to connect NB7W (NB
connection) with PC
1
Make Network Setting in the [HMI] tab in [HMI Attribute] dialog box of NB-Designer. (e.g. IP is
192.168.250.1; Subnet Mask is 255.255.255.0 and Default Gateway is 0.0.0.0.)
2
Set the DIP Switch of this HMI to "1 ON" and "2 ON", and then make the Network Setting: IP,
Port, Subnet Mask and Gateway (Network Setting also available for the HMI with Ethernet
interface).
3
Make the Network Setting in this mode same as that in the HMI tab of NB-Designer. (e.g. IP is
192.168.250.1 and Subnet Mask is 255.255.255.0.)
4
Restart the HMI, and then check if the IP and Subnet Mask are set successfully.
5
Set the IP address of PC and that of HMI locating in the same network segment with the first 3
parts being same and the last part being different (e.g. IP is 192.168.250.2 and Subnet Mask is
255.255.255.0.).
6
Use the network cable to connect HMI and PC, and then the project can be downloaded
immediately.
Note For the details of Ethernet connection, refer to NB-Designer Operation Manual.
5-4
-TW01B supporting Ethernet
Ethernet Cable
NB-series Programmable Terminals Startup Guide Manual(V109)