Omron NB3Q-TW_B Startup Manual page 112

After a password is set, the password needs to be entered correctly to carry out uploading, or
not, the uploading cannot proceed; you can disable uploading completely by deselecting [Allow
Upload]. If [Allow Decompilation] is selected and a password is set, the correct password is
required to be entered to proceed with decompilation. If [Allow Decompilation] is deselected,
decompilation cannot be performed even after a project is uploaded.
Note that if the project is large and decompilation is not required, then decompliation can be
deselected to save the storage space of the HMI.
32
How to mask system alarm information - PLC No Response
Place a [Bit State Setting Component] in the Common Window, with the address being LW.B
9296.2 and the setting type being [Set On when Window Open].
33
How to mask system alarm information - Socket Connect Error
Place a [Bit State Setting Component] in the Common Window, with the address being LW.B
9296.4 and the setting type being [Set On when Window Open].
34
How to achieve multi-language switch
Multi-language switch can be achieved through changing the value of the special register
LW9130. The default setting is: LW9130=0, with the corresponding language 1.
NB-Designer supports up to a maximum of 32 languages. The following is an example of
Chinese - English switching:
LW9130=0: Language 1 Chinese
LW9130=1: Language 2 English
(a) Create a text in the text library, as shown below:
NB-series Programmable Terminals Startup Guide Manual(V109)
6 Maintenance and Troubleshooting
6
6-23