Omron NB3Q-TW_B Startup Manual page 37

2 System Design
• The garage door will not be closed before the CLOSE switch is pressed or the vehicle sensor is
ON after being fully opened.
• The garage door will be closed when the sensors detect that the entire vehicle is in the garage.
• If [Deactivate Auto-close] button is pressed, the garage door will not be closed even if the vehicle
sensor is ON.
• Please control the garage door using related switches on the display device when the vehicle is
being driven out of the garage.
• NB7W will display maintenance screen for checking input devices when the maintenance button is
pressed.
System Components
The following components are used in the garage door control system:
Display device
• NB7W-TW
• XW2Z-200T(PT-PLC connecting cable: 2m)
• XW2Z-500T(PT-PLC connecting cable: 5m)
PLC
• CP1E-N20D -
Programming device and software
• Personal computer
• USB cable (A-type connector(male) - B-type connector(female))
• NB-Designer Ver1.1X (screen programming tool for NB series)
• CX-Programmer (PLC programming tool)
2-4
a [Deactivate Auto-close] button
a Maintenance button
B
(20-dot I/O type)
a
NB-series Programmable Terminals Startup Guide Manual(V109)
a