Omron NB3Q-TW_B Startup Manual page 75

4 Screen Creation
The whole screen is shown below. The creating methods for fixed text and Bit State Setting
components for [Open], [Stop] and [Close] garage door operations are the same as that of [1 Wait].
a
b
d
a Screen b Fixed Texts c Bit State Lamp d Function Keys e Bit State Setting components
Bit State Lamp
The states of the vehicle sensor, light sensor, upper LS and lower LS are shown by the lamp.
The attribute settings for the Bit State Lamp are:
Corresponding
Name
Read Address
Function
Tag
Graphics
Function Key Components
These are used for switching to [1 Wait] and [7 Check 2] screens.
The attribute settings of the Function Key components are:
Screen Name
Function Key
Tag
Graphics
[7 Check 2]
The [7 Check 2] screen will appear after the screen-switching button on [6 Check 1] or
[8 Check 3] screen is pressed.
Configure functions below:
• Fixed text indicating the garage door state.
• Bit State Lamp components activating relevant lamp to check operations when the [OPEN], [STOP]
or [CLOSE] Function Key turns ON.
• Function Key component, a button for switching to [6 Check 1] and [8 Check 3] screens.
• Bit State Setting components, allocated to [Open], [Stop] and [Close] garage door operations
respectively.
4-22
c
Vehicle Sensor Light Sensor
CIO 0.03 CIO 0.04
Normal
Do not use
Use the vector graphic: Lamp2State1-00.vg
Wait Screen
Switch to base window [1 Wait]
Use tags:
0: Wait Screen
1: Wait Screen
Use the vector graphic: CTRL_BAR001.vg
Upper LS
CIO 0.05
Switch to base window [7 Check 2]
Use tags:
0: Next Screen
1: Next Screen
NB-series Programmable Terminals Startup Guide Manual(V109)
e
Lower LS
CIO 0.06
Next Screen