Using Fm Radio Mode; Tuning A Station; Scan Modes - Goodmans 335105 User Manual

Using FM Radio Mode

4.10 Tuning a Station

1. You can scan up or down the frequency range manually by pressing the >>| / |<<
buttons to increase or decrease the frequency in 0.05 MHz increments.
2. To scan through the frequency range quickly press and hold either >>| / |<< buttons.
3. Once a station has been found, the scanning will stop automatically. If no station is
found, then the tuning will stop once it has cycled through the entire FM band (87.5 -
108MHz).
4.11 Positioning the Antenna
Positioning of the aerial will influence the FM signal quality.
Make sure that the telescopic antenna on the rear of the DAB Micro System is fully
extended and in a vertical position. This will ensure that the maximum signal strength is
available.

4.12 Scan Modes

When performing a scan you can set the sensitivity level of the stations to be found. EG:
strong signals only or all stations.
1. In FM mode, press the MENU button, when <Scan Setting> appears on the display
Press the centre of the SELECT button to view the submenu.
2. Use the SELECT button to select ALL STATIONS (which will detect any station, even
with a weak signal) or STRONG STATION (which will only detect stations with a good
signal strength). Press the centre of the SELECT button to select the required option.
4.13 Stereo / Mono Modes
Sometimes Stereo radio stations can suffer from interference (static & crackles) to reduce
this problem you can enable MONO mode.
1. In FM mode, press the MENU button.
2. Using the SELECT button choose <Audio Setting> and then press the centre of the
SELECT button.
3. Use the SELECT button to choose between STEREO ALLOWED or FORCED MONO.