Radio Station Presets - Goodmans 336723 User Manual

4 Operation
To fne tune the frequency press either of the
3.
hold), to jump 0.05 MH.z
There is an auto scan function that will scan the entire frequency range and
4.
store all located stations in the preset memory slots.
To use this function press and hold the AUTOSCAN button on the remote (23). The
unit will scan the frequency band and stop when finished.
See 'Radio station presets' below for details on how to recall located stations.
NOTE: Placement of the aerial is important to get a good FM signal. If you are
having problems tuning a station, moving the aerial may improve the reception. If
not try moving the unit to another location.
If you are experiencing poor stereo FM reception, you can press the FM ST.
5.
button (7,21) to revert to MONO mode which can clean up the reception.
Stereo mode is indicated by this icon '
NOTE: Not all stations will allow this function.

Radio station presets

4.8
It is possible to store up to 20 preset stations.
The below steps will explain how to store & recall them.
With a radio station tuned, press and hold the PRESET button (8,26). You will
1.
see a P01 fash on the display to indicate preset 01.
If you wish to store the current station in slot 01 press the PRESET button again
2.
to store. Should you wish to use another slot use the NAVIGATION
buttons (26/35) to cycle through slots 1-20 until you reach the slot you wish to
use.
Press the PRESET button to store the station in the selected slot.
3.
To recall stations stored in preset slots use the NAVIGATION buttons (26/35) to
4.
cycle through slots 1-20. Each press will play the stored station on that slot. If
no station is stored then static will be heard.
buttons (do not press &
'.
336723