3D Systems projet mjp 2500 User Manual page 81

Printer Status Code
94-203 Planarizer Contact Calibration
Failed
94-104 Printer Slowing Down
95-118 Build Chamber Too Hot
92-157 Y Axis Motor Cannot Home
94-207 Clean Print Carriage and
Optical Home Sensor
Issue Description
Planarizer Contact Calibration Failed prior to printing, the
printer calibrates the planarizer gap. If it fails, the printer will
wait fo the user to remove and re-position the plate.
Printer slowing down to cool
Build Chamber Too Hot while printing, if the printer shows
slowing down to cool, the build chamber is above optimal
temperature. If it continues to exceed temp, the printer will
pause printing until the temperature goes down.
Sensor may be dirty
Customer Troubleshooting Steps
1. Access Platform from the UI > Status Tab
2. Open top door
3. Remove print platform
4. Clean both sides of the print platform
5. Replace print platform
1. Close top door
1. Check ambient temperature, optimal temperature range
is 18°-24°C (64°-75°F).
2. Verify that the particulate filter and the screen above the
filter are not plugged. Replace as necessary.
3. Make sure the printer is not next to a window in direct
sunlight.
4. Make sure the back of the printer is 12" from the wall.
Clean Print Carriage Optical home sensor. See
Maintenance section for cleaning sensors.
Cleaning and