3D Systems projet mjp 2500 User Manual page 17

1. Printer Info - Information about the printer can be found here.
2. Diagnostics - Many diagnostic procedures can be run under the Diagnostics button. See Diagnostics Menus below for more information.
3. Material Change Wizard - To change from one type of material to another there is a flush operation that you have to perform to ensure all of the first
material is out of the printer before adding a new material. This is where you run this routine to perform this. See Troubleshooting section Material Change
Over procedure for instructions.
4. Printer Usage - The printer usage can be checked here.
5. Waste Bag - The waste bag needs to be changed as it fills up. There is a procedure for changing the waste bag, see Steps for Printing Your First
Print section Changing Waste Bag for more information.
6. Operator Maintenance - Selecting Operator Maintenance will bring up a maintenance schedule. Be sure to click on a maintenance item and Reset the
counter once the cleaning has been completed, otherwise a message will appear that the maintenance is over due. Before performing any maintenance routines
the printer must be in a Ready state and a clean print platform must be installed.
7. Save Log - Saved logs are stored here.
8. Shutdown - The recommendation is that the printer always be shutdown through the UI. See Steps for Printing Your First Print section Printer
Shutdown for information.
Diagnostics Menus - Selecting the Diagnostics button under the Tools Tab will bring up the Diagnostics screen is where the User performs routines that
help run and maintain the printer.