Table of Contents
Advertisement
Before connecting the
headphones, active speakers or
audio connecting cable to the
player
Be sure to attach the supplied clamp filter to
each cable connected to the i PHONES jack
and the
AUDIO OUT jack, following
the procedure below. (You must affix the
ferrite cores to comply with applicable EMC
standards.) The clamp filter should be
attached on one end of the cable, as close to
the plug as possible that is connected to each
jack.
(1) Open the clamp filter.
Speakers
Right speaker, rear panel
1 Speaker cord
Connect this cord to the R OUT
connector on the left speaker. (5)
2 R OUT connector
Connect the speaker cord from the right
speaker. (5)
(2) Wind the cable into the clamp filter as
shown below.
(3) Close the clamp filter.
Make sure the clasps
are fully engaged.
Left speaker, rear panel
3 Speaker cord
Connect this cord to the SPEAKER
OUT connector on the main unit. (5)
As close to the
plug as possible.
57
GB
Advertisement
Table of Contents
