Dividing A Recorded Track Into Two Tracks (Divide Function) - Aiwa ADN-1 Operating Instructions Manual

Dividing a recorded
track into two tracks
(Divide Function)
You can divide one track into separate
tracks, and add a new track mark to each
track. All tracks following the divided tracks
are renumbered.
Example: Dividing track 1 into two tracks
Track number
,
Dividing Track 1 is divided, and the track
mark 2 is added.
1
While playing the MD, press MD X at
the point where you want to create a
new track.
The player pauses.
2
Press EDIT repeatedly until "Divide"
appears in the display.
GB
34
3
Press YES.ENTER.
"Divide OK?" appears in the display.
If you want to cancel the Divide
Function at this point:
Press NO.CANCEL or x.
4
Press YES.ENTER.
"Complete" appears in the display for a
few seconds after the track is divided.
The original track only has the track
name, while the new track has no name
(this happens only when the track you
divided had its track name).
Tip
To put the divided tracks together, see
"Combining two adjacent tracks into a single
one".
Notes
• If "Sorry" appears in the display, you cannot
divide the track.
If you repeat editing on the MD, you may not be
able to divide a track. This is due to the system
limitations of the MD (page 61), but not caused
by malfunction.
• You cannot divide a track that is checked out
from a computer (page 46). If you attempt to do
so, "Trk Protect" appears in the display.
For more information, see the "SonicStage Ver.
1.5" manual, and the "SonicStage Ver. 1.5 Help"
electronic manual.
After you stop editing,
•
do not disconnect the
mains lead or move the player while
"TOC EDIT" is flashing in the display. If
you do so, editing may not be done properly.