Table of Contents
Advertisement
MD
Problem
"REC Error", "READ Error", or "TOC Error"
are displayed, and the disc cannot be used
" - - - : - -" appears in the display instead of the
playing time or the remaining time.
MD does not play
Play does not start with the first track on the MD
The MD does not record
High-speed recording does not work
Possible solutions
• The MD maybe dirty or scratched. Try a different
MD.
• This player can display the time up to 999 minutes 59
seconds. If the time is longer than this, it will be
displayed as "- - - : - -".
• Take out the MD and leave the player in a warm place
for several hours until the moisture evaporates.
• The MD is inserted in the wrong direction. Slide the
MD into the disc compartment with the label side
right and the arrow pointing towards the opening until
the player grips it.
• The MD may be blank ("Blank Disk" appears).
Replace the disc with one that has been recorded.
• The Resume function may be enabled. Press
RESUME / INTRO to until "Resume Off" appears in
the display.
• Group mode may be turned on. Turn Group mode off
and try playing again.
• The MD is record-protected ("Protected" appears).
Close the record-protect slot.
• The track has been protected using another MD
recorder ("Trk Protect" appears). Release the track-
protect on the same MD recorder that protected the
track.
• The player is not connected properly to the sound
source. Make connections properly to the sound
source.
• A pre-mastered MD is inserted. Replace it with a
recordable MD.
• There is not enough space left on the MD. Replace it
with another recordable MD with enough space, or
erase unnecessary tracks.
• There has been a power failure or the mains lead has
been disconnected during recording or while "TOC
Edit" is flashing. Data recorded to that point may be
lost. Repeat the recording procedure.
• You may be attempting to use high-speed recording
with a CD track that has already been recorded using
high-speed mode in the previous 74 minutes (page
61).
• High-speed recording may not be possible because
there is less than a track of free space on the MD
("Error" appears in the display).
• High-speed recording cannot be done from a CD-RW
disc.
continued
GB
51
Advertisement
Table of Contents
