Draining The Internal Water Circuit And Hoses For Disinfection - Stryker altrix Quick Start Manual

Quick start guide for
Altrix Precision Temperature Management System
Disinfecting
Disinfect the internal water circuit and hoses every 14 days
Use the BruClean TbC disinfectant tablets by Brulin (EPA registration
number 71847-2-106) before first use, at least every 14 days, and before
storage. BruClean TbC has been validated for internal water circuit
disinfection. Make sure that you follow the disinfectant manufacturer's
guidelines to avoid the risk of injury. Failure to follow the disinfectant's
instructions may void your warranty.
• Always use sterile distilled water or water that has been passed
Caution
!
through a filter less than or equal to 0.22 microns with this product.
• Do not disinfect the internal water system with a thermal transfer
device attached as this may cause a leak.
Note: Disinfection • Do not use bleach or any other cleaning or disinfectant agents for
of the Altrix internal circuits. This could result in damage to the product. Only
internal water use approved disinfectant tablets.
system was • Always drain the product before disinfecting the internal water
validated using circuit. Failure to drain the product may reduce the effectiveness
M. mucogenicum. of the disinfection process.

Draining the internal water circuit and hoses for disinfection

1. Unplug the power cord from the wall outlet.
2. Place the controller over a floor drain.
Note: For best results, the floor drain should be within reach of a wall outlet to power on the controller.
3. To drain the controller, pull up on the controller drain plug (A) to open the
drain (Figure 24). Leave the drain open.
8001-069-002 Rev B.2 Refer to the Altrix Precision Temperature Management System Operations Manual for additional information.
Tools required:
• 2 gallons (11.4 L) of sterile distilled water or water that has been passed
through a filter less than or equal to 0.22 microns
• Personal protection equipment (PPE) as recommended by the disinfectant
manufacturer's instructions
• Soft, lint free cloth (2 or more)
• 2 BruClean TbC 13.1 g tablets (Active ingredient NaDCC solution ppm =
1874 mg/L)
Note: BruClean TbC is a blend of 48% sodium dichloroisocyanturate and
Adipic Acid with a 5% sodium dodecyl benzene sulphonate surfactant.
• Service tool adapter hose (8001-999-017) for Colder style connector hoses
• Floor drain
See Product illustration on page 10 of the manual for clarification of product
component names and locations.
Figure 24
card 9A