Introduction INTRODUCTION This manual is designed to assist you with the operation of the 2100 Childbearing Bed. Read it thoroughly before using the equipment or beginning any maintenance on it. SPECIFICATIONS Maximum Weight Capacity 550 pounds (249 kilograms) Electrical 3 motor function: Head–Bed–Foot 6 function patient comfort 120 VAC, 60 Hz, 4 Amp –...
Refer to unpacking instructions located on outside of marked crate. SET–UP PROCEDURES It is important that the Stryker Adel 2100 Childbearing Bed is working properly before it is put into service. The following list will help assure that each part of the bed is tested.
Bed Illustration I.V. Pole Patient Grasping Handles Removable Foot End Mattress Brake/Steer Pedal Trendelenberg Pedal Hand Pendant Control Leg Support Bracket Foot Pan Latch...
Bed Operation BASE PEDAL OPERATION The Brake/Steer pedals are located on the base at the head end of the bed. The functions are clearly marked on the pedals. For Trendelenberg (tilt), press down on the pedal on either side of the bed and lean on the head end of the bed.
Bed Operation OPERATING SIDERAILS To lower the siderail, pull out on the handle located in the center of the siderail and lower the siderail down. To raise the siderail, pull out on the handle and lift the siderail until it locks. USING GRASPING HANDLES There are two patient grasping handles, one on each side of the litter (see bed illustration page 4).
Nurse Communication Siderail Operation Guide 1. Push to raise Fowler. 2. Push to raise bed height. 3. Push to raise foot section. 4. Push to lower Fowler. 5. Push to lower bed height. 6. Push to lower foot section. 1. Push for more support to the patient’s lower back.
Page 9
Nurse Communication Siderail Operation Guide Push to activate Nurse Call. 1. Push to turn room light on or off. 2. Push to turn reading light on or off. On nurse control (outside) of siderail only: Push to lock out bed motion and mattress inflating functions. Push to unlock bed motion and mattress inflating functions.
Hand Pendant Control Operation Guide USING HAND PENDANT CONTROL 1. Press to raise bed height. 7. Press to raise foot section. 8. Press to lower foot section. 2. Press to lower bed height. 9. Press for more support to the patient’s lower 3.
Adel will file a freight claim with the appropriate carrier for damages incurred. Claim will be limited in amount to the actual replacement cost. In the event that this information is not received by Stryker Adel within the fifteen (15) day period following the delivery of the merchandise, or the damage was not noted on the delivery receipt at the time of receipt, the customer will be responsible for payment of the original invoice in full.