Network Capture - Honeywell MX7 TECTON User Manual

Network Capture

Start > Settings > Control Panel > Network Capture
Verify the MX7 Tecton
The Network Capture panels provide configuration options for logging utilities.
Two types of logging are configurable:
Netlog is a Windows CE utility that monitors network traffic. Netlog creates a .CAP file that can be read using Microsoft
Windows Network Monitor or any compatible tool that supports .CAP files.
NDISLog monitors the NDIS interface between the Summit radio and the NDIS driver. This utility creates a .TXT log file.
Setting
Netlog
Command
pkt_size in bytes
cap_size in bytes
.cap file
Promiscuos Mode
NDISLog
Command
file
Netlog
Use this control panel to configure the Netlog utility. By configuring Netlog using the control panel, Netlog remains run-
ning across a warmboot. However, note that:
• Netlog first stores data to a file named netlog0.cap, then netlog1.cap. Any time the current file reaches maximum
size, Netlog switches to the other file.
• If the log file is stored in the root directory, any previous data is lost and a new log file started after the warmboot.
• If the log file is stored in \System, all previous data is saved across the warmboot.
• If Netlog is enabled across the warmboot, a series of brief popups may be displayed during the boot cycle. No user
interaction is required.
5 - 44
Date / Time (page 5-22) before using the logging utilities to ensure meaningful data.
Default
options
5000
500000
\netlog
Disabled
stop
\ndislog.txt