Chapter 10 - Enabler Installation And Configuration; Introduction; Installation; Installing The Enabler On Mobile Devices - Honeywell MX7 TECTON User Manual

10
Enabler Installation and Configuration

Introduction

This section discusses Honeywell supported features of Wavelink Avalanche Mobile Device Servers. This section is split into
three basic areas:

• Installation

• User Interface
• Enabler Configuration
Installation
To use the Wavelink Avalanche MC System, the following items are required:
• A desktop or laptop PC on which to install the Avalanche MC Console.
• A desktop or laptop PC on which to install the Avalanche Mobile Device Server (this can be the same PC where the Avalanche
MC Console is installed).
• Wavelink Avalanche MC Console 4.2 or later.
• A Wavelink Device License for each client device.
To use Avalanche Remote Control, the following additional items are required:
• Wavelink Remote Control plug-in, 2.0 or later
• A Wavelink Remote Control License for each client device

Installing the Enabler on Mobile Devices

Mobile devices have the Avalanche Enabler installation files loaded, but not installed, on the mobile device when it is shipped.
The installation files are located in the \System folder.
Note: Important: If the user is NOT using Wavelink Avalanche to manage their mobile device(s), the Enabler should not be
installed on the mobile device(s). Doing so results in unnecessary delays when booting the device.
The Avalanche Enabler installation file HSM_ENABLER_CAB is loaded on the MX7 Tecton by Honeywell; however, the device
is not configured to launch the Enabler installation file automatically. The installation application must be run manually the first
time Avalanche is used.
After the installation application is manually run, the Enabler will, by default, be an auto-launch application.
This behavior can be modified by accessing the Avalanche Update Settings panel through the Enabler Interface.
The RMU.CE.CAB file is placed on the device during manufacturing in the \System\RMU folder.
During the Enabler installation process, the Enabler checks for the RMU.CE.CAB file in the \System folder.
• If present, it assumes the RMU.CE.CAB file is already installed and continues.
• If the file RMU.CE.CAB file is not present, it looks for the file in the \System\RMU folder.
• If present, the Enabler copies the file to the \System folder and installs it.
At this point, the OS will automatically install the RMU (Remote Management Utility) after the MX7 Tecton reboots.
10 - 1