Bluetooth Reader Beep And Led Indications; Bluetooth Printer Setup - Honeywell MX7 TECTON User Manual

Bluetooth Reader Beep and LED Indications

Bluetooth Mobile Device Beep Type
Beep Type from Bluetooth Device
Acknowledge label
Label rejected
Transmission error
Link successful
Link unsuccessful
Bluetooth Mobile Device LED
LED on Bluetooth Device
Yellow LED blinks at 2 Hz
Off
Yellow LED blinks at 50 Hz
Yellow LED blinks at the same rate as the paging beep
(1 Hz)
Green LED blinks once a second
Upon startup, if the Bluetooth mobile scanner sounds a long tone, this means the scanner has not passed its automatic Selftest
and has entered isolation mode. If the scanner is reset, the sequence is repeated. Contact
you need help.

Bluetooth Printer Setup

The Bluetooth managed printer should be as close as possible, in direct line of sight, with the MX7 Tecton during the pairing pro-
cess.
1. Open the Bluetooth control panel on the MX7 Tecton.
2. Tap Discover. Locate the Bluetooth printer in the Discovery panel.
3. Tap and hold the stylus (or double-tap) on the Bluetooth printer until the right-mouse-click menu appears.
4. Select Pair as Printer to pair the MX7 Tecton with the Bluetooth managed printer.
The devices are paired. The Bluetooth managed printer may respond with a series of beeps or LED flashes.
Refer to the Bluetooth managed printer manufacturer User's Guide; it may be available on the manufacturer's web site. Contact
Technical Assistance (page 16-1) for Bluetooth mobile device help.
Note: If there is no beep or no LED flash from the Bluetooth managed printer, the MX7 Tecton and the printer are currently
paired.
7 - 12
Behavior
1 beep
2 beeps at low frequency
Beep will sound high-low-high-low
Beep will sound low-medium-high
Beep will sound high-low-high-low
Behavior
Linking in progress
Disconnected or unlinked
Bluetooth transmission in progress
Paging
Disabled indication
Technical Assistance (page 16-1) if