Scan Barcodes; About Scanning Configuration Barcodes - Honeywell CN80 Series User Manual

6. Tap Choose Application.
7. Check the box next to all the applications where you want the digital scan
8. Select OK.
9. Tap Back to return to the Settings screen.

Scan Barcodes

By default, the computer imager is enabled for scanning. It supports
omni-directional (360°) barcode scanning and an aiming beam is provided to help
assist with targeting barcodes.
Before you start scanning barcodes, go to Settings > Honeywell Settings >
Scanning > Internal Scanner and modify the scan profile to enable only the
barcode symbologies that you need. By reducing the active symbology list, you can
increase scan speed.
1. Point the scanner window at the barcode. For optimum performance, avoid
2. Press and hold any Scan button.
3. Center the aiming beam over the barcode. Make sure the entire barcode is
4. Release the Scan button when the computer beeps, and the Scan Status LED
Note: Not all barcode symbologies are enabled by default. If a barcode does not scan, the
correct symbology may not be enabled.

About Scanning Configuration Barcodes

After completing the out-of-box set up process, Provisioning mode is
automatically turned Off. Scanning a barcode to install applications, certificates,
configuration files, and licenses on the computer is restricted unless you enable
Provisioning mode in the Settings app.
54
button to be available.
The digital scan button appears on the screen when you open any of the apps
you selected during the button setup. Tap and hold the button to activate the
imager and scan a barcode.
reflections by scanning the barcode at a slight angle.
inside of the illumination frame.
briefly turns on. The barcode information is entered into the application in use.
CN80 Mobile Computer Series User Guide