Connecting Power Cable(S) - H3C S9500 Series Installation Manual

Installation Manual
H3C S9500 Series Routing Switches
Table 3-2 Procedure of installing NEPS3500-A
Step
Install the
NEPS3500-A
enclosure
into the
switch
Install 1800
W
sub-PSU(s)
to the
NEPS3500-A
enclosure
Figure 3-10 Install a 1800 W sub-PSU

3.6.3 Connecting Power Cable(s)

I. Connecting the AC power cord
Caution:
For lightning protection, the AC power supply should be led through an
external lightning device into the switch.
Make sure the power switch on the PSU is in the OFF position before
connecting the AC power cord.
Take the following steps to connect the AC power cord to NEPS1200-A, or
NEPS2000-A:
1) Turn the clamp at the left of the PSU front panel rightwards.
2) Insert the plug at one end of the AC power cord into the socket of the
PSU.
3) Turn the clamp leftwards until it grips the plug.
1) Hold the handle on the enclosure with one hand and
the bottom with the other hand, and gently slide the
enclosure along the guide rails into the switch.
2) Fasten the captive screws on both sides of the
enclosure with a Philips screwdriver.
3) Check that the power switch on the enclosure is in the
OFF position.
1) Pull down the handle on the sub-PSU (refer to the
leftmost graph in
2) Slide the sub-PSU smoothly along the guide rails, until
it snaps into the backplane.
3) Push the handle upward so that the sub-PSU moves
further inside about 1 cm (0.39 in) until the handle
locks the sub-PSU in place, as shown in the rightmost
graph in Figure
3-11
Chapter 3 Installing the Switch
Sub-step
Figure 3-10).
3-10.