Table of Contents
Advertisement
Checking drive chain tension
Important
Have chain tension adjusted by a Ducati Dealer
or Authorized Service Center.
Turn the rear wheel until you find the position where
chain is tightest. Set the vehicle on the side stand.
With just a finger, push down the chain at the point
of measurement and release.
Measure the distance (A) between the center of the
chain pins and the aluminum section of the swinging
arm. It must be: A = 2.2 ÷ 2.3 in (56÷ 58 mm).
This only applies to the motorcycle standard settings,
available upon delivery.
Important
If the drive chain is too tight or too slack, adjust
it so that tension reading will fall within specified
range.
372
A
A
Fig 271
Advertisement
Table of Contents
