Table of Contents
Advertisement
If the LAP function is not selected from the menu, the
instrument panel will go back to the functions present
before the FLASH button (3) was pressed.
It is possible to scroll the other menu functions at any
time.
When storing the 15th LAP, the LAP function is
stopped and, upon any further press on the FLASH
button (3), the instrument panel will display flashing
FULL message for 4 seconds warning that the
storage space for lap times is full.
Note
When the LAP function is active, the FLASH
button takes on the dual function of high beam flash.
LAP recording
If the LAP function is active, the lap time can be
recorded for a total of 15 consecutive laps.
Operation:
If the time is never stopped, it will roll over upon
reaching 9 minutes, 59 seconds and 99 hundredths;
the lap timer starts counting from zero and will keep
running until the lap is stopped or the recording
function is disabled.
During every lap, the following data are stored:
-
no. 15 lap times (time between consecutive start
and stop);
-
no. 15 values for max. RPM (maximum RPM
value reached in every lap);
-
no. 15 values for max. speed (maximum speed
value reached in every lap).
135
Advertisement
Table of Contents
