Lubrication Locations; Maintenance Schedule - Ventrac MR740 Operator's Manual & Parts Drawings

Lubrication Locations

Grease the reel mower in the locations shown in the following diagram using a lithium complex NGLI #2 grease.
Wipe off any excess grease or oil.

Maintenance Schedule

Maintenance
Schedule
Lift Arm Pivot
Cutting Unit Carrier Pivot
Rear Roller Bearing
Front Roller Bearing
Reel Bearing
Cylinder End
Motor Shaft Spline
Check Hydraulic Oil Level
Change Hydraulic Oil and Filter
Inspect for Loose, Missing, or Worn
Components.
Inspect Drive Belt, Pulleys, Blades, Fittings,
and Hydraulic Hoses
Inspect Safety Decals
** Operation in severe conditions may require more frequent service intervals.
^ Grease Until Fresh Grease is visible
% Clean and relubricate with a thin film of grease
Grease & Lubrication: See Lubrication Section
2 ^
                   
3 ^
                   
6 1 **
                   
6 1 **
                   
6 1                    
4 ^
                   
3 % 
Hydraulic System




SERVICE

Inspection
Service - 21
  
