Table of Contents
Advertisement
Rotor Drive Belt Tension Adjustment
If the belt slips during normal operation, the belt ten-
sion will need to be adjusted.
1. Remove the rotor drive cover (A).
2.
Loosen the jam nut (C) and tighten the adjustment
nut (B) until there is approximately .8 - 1.6 mm
(1/32 - 1/16 inch) gap between the spring coils.
3.
Tighten the jam nut against the adjustment nut to
lock the spring tension rod in place.
4. Reinstall the rotor drive cover. Torque the bolts to
24 Nm (210 in-lbs).
SERVICE
A
B
C
Service - 22
Lubrication Locations
Lubrication is required at the following locations using
a lithium complex NLGI #2 grease.
Wipe the grease fittings clean before applying grease
to the grease fittings.
Refer to the maintenance schedule for service intervals
and the amount of grease.
Detach the flail mower from the power unit and re-
move the rotor drive cover.
Set the height adjustment handles to position # 1 or 2.
Grease the rear carrier rockers.
Set the height adjustment handles to position # 15.
Grease the wheel axles and the wheel caster pivots.
Grease the rotor bearings and the cross pivot frame
swivels on both sides of the deck.
Advertisement
Table of Contents
