Servicing Right-Side Components - Arctic Cat HDX 700 2017 Service Manual

MD1017
19. Remove the snap ring holding the oil pump driven
gear.
MD1019
NOTE: Always use a new snap ring when installing

the oil pump driven gear.
20. Remove oil pump driven gear. Account for the drive
pin and thrust washer.
MD1020
AT THIS POINT

To service clutch components, see Servicing Right-Side
Components sub-section.
G. Oil Pump/Oil Strainer
NOTE: Steps 1-20 in the preceding sub-sections

must precede this procedure.
21. Remove three cap screws holding the oil pump and
remove the oil pump. Account for two alignment
pins.
MD1060
22. Remove the four cap screws securing the oil strainer
cap; then remove the Phillips-head screws securing
the oil strainer. Account for the O-ring.
MD1337
MD1208
AT THIS POINT

To service center crankcase components only, proceed
to Separating Crankcase Halves.
Servicing Right-Side
Components
INSPECTING CENTRIFUGAL CLUTCH
SHOE
Inspect the clutch shoe for uneven wear, chips, cracks, or
discoloration. If wear is present, replace the clutch
assembly.
67