Section 9 Read And Change Settings; System Time And Synchronization; System Time; Time Synchronization - ABB REL670 Operator's Manual

1MRK506276-UUS B
Section 9
9.1
9.1.1
9.1.2
9.1.2.1
Operator's manual
Read and change settings
About this chapter
This chapter describes how to find and change settings and parameters. The chapter is
divided into two sections which match the way the two categories of settings are
divided up in the HMI. The General settings group consists of those parameters that
cause an automatic restart of the IED. The Setting group N consists of six groups of
settings with default values for all parameters. These do not require or cause a restart
once they have been changed. Time, synchronization and the activation of setting
groups are also dealt with here.
It takes a minimum of three minutes for the IED to save the new
settings, during this time the DC supply must not be turned off.
Do not perform a setting change at the same time as a hardware
reconfiguration. Doing so might cause the IED to malfunction.

System time and synchronization

System time

Main menu/Settings/Time/System time
Under System time, the system clock date and time are set.

Time synchronization

Overview

The synchronization settings are divided into categories Time synch, Time synch BIN,
Time synch SNTP, Time synch DST Begin, Time synch DST End, Time synch time
zone and Time synch IRIG-B. The settable parameters are found under each category.
Section 9
Read and change settings
39