Technical Level; Menu System Of Parameters; How To Change Settings - ABB REF 610 Operator's Manual

1MRS755539
4.2.2.
4.2.2.1.
4.2.2.2.
Feeder Protection Relay
Operator's Manual - ANSI Version

Technical level

Menu system of parameters

Press an arrow button to activate the main menu. If the default password is in use,
no password is required to change the parameters. If the password protection is in
use, "***" is shown on the display until you give the valid HMI password.
The views are used for reading and setting parameters, which are divided into two
main groups:
SETTINGS
*
CONFIGURATION
*

How to change settings

The actual settings consist of the settings of group 1 or group 2, depending on which
group has been selected to be active (indicated by an asterisk "*"). The actual
settings can be seen in the first parameter menu, for example:
SETTINGS\PROTECT. ELEMENTS\59P-1 VTx0.00
Submenu
SETTINGS
51P CT :0.00
Fig. 4.2.2.2.-1 Setting parameters in setting group 1 and setting group 2
By switching between setting groups 1 and 2, you can activate a whole group of
settings at the same time. Switch between the setting groups as follows:
With the parameter GROUP 1/GROUP 2 under the main menu group
*
SETTINGS.
With a digital input signal, provided that SGB1...5/4 has been set to 1 in both
*
setting groups (GRP1 and GRP2).
With parameter V150 via the SPA bus.
*
When a large number of settings is to be altered, for example during
the commissioning of the relay systems, use a PC equipped with the
necessary software.
If no PC is available, or when only a few settings are to be altered:
Parameter Menu
SETTINGS
* GRP 1 :x.xx
GRP 2 :x.xx
REF 610 REF 610
Confirm
Cancel
A070069
31