Technical Level; Menu System Of Parameters; How To Change Settings - ABB REF 610 Operator's Manual

REF 610
3.2.2.
3.2.2.1.
3.2.2.2.
22
Feeder Protection Relay
Operator's Manual - ANSI Version
Main Menu
MEASUREMENTS
RECORDED DATA
OPERATION
SETTINGS
CONFIGURATION
INFO INFO
xxxxxxxx
YYYYMMDD
Fig. 3.2.1.4.-1 Info

Technical level

Menu system of parameters

Press an arrow button to activate the main menu. If the default password is in use,
no password will be required to change the parameters. If the password protection is
in use, "***" will be shown on the display until you give the valid HMI password.
The views are used for reading and setting parameters, which are divided into two
main groups:
• SETTINGS
• CONFIGURATION

How to change settings

The actual settings consist of the settings of group 1 or group 2, depending on which
group that has been selected to be active (indicated by an asterisk "*"). The actual
settings can be seen in the first parameter menu, e.g. SETTINGS\PROTECT.
ELEMENTS\ 51P CT x 0.00
SETTINGS
CT x 0.00
51P
Fig. 3.2.2.2.-1 Setting parameters in setting group 1 and setting group 2
By switching between setting groups 1 and 2, you can activate a whole group of
settings at the same time. Switch between the setting groups as follows:
• with the parameter GROUP 1/GROUP 2 under the main menu group
SETTINGS.
Parameter Menus
REF 610
INFO
1MRS118512 A
CPU MODULE
xxxxxxxx
COM. MODULE
INFO
1MRS118531 A
xxxxxxxx
DNP 3.0
.
SETTINGS
* GRP 1 x.xx
Confirm
GRP 2 x.xx
Cancel
1MRS 755539
Cancel
INFO
xxx
INFO
xxx