Transferring The Parameter Setting Data - Siemens SIMATIC S5 CP 523 Manual

Print Mode
STL FB 10
:
:L FW 228
:L FW 128
:! = F
:BEC
:L FW 128
:T FW 228
:L FY 128
:T PY 128
:L FY 129
:T PY 129
:BE
6.7.8 Transferring the Parameter Setting Data (Job Number 90
You can transfer data for a parameter block to the CP 523 with a "Transfer parameter setting
data" request:
• Data for the serial interface (corresponds to parameter block 0 on the memory submodule)
• Characters for XON/XOFF protocol (corresponds to parameter block 2 on the memory
submodule)
• Setting the mode and the parameters (corresponds to parameter block 7 on the memory
submodule)
Note:
"Transfer parameter setting data" job is almost without significance in Print mode since the
parameter setting data for Print mode are stored in DB 1 on the memory submodule.
A typical application might be if you want to replace a defective printer temporarily with
another printer whose interface has been configured differently.
The job does not change the contents of the memory submodule plugged into the CP 523.
After a warm restart, the CP continues to use the data on the memory submodule.
See 7.3.2 for a detailed description.
6-48
Load old value
Load new value
Compare for equal
Block End if equal
Update old value if not equal
transfer flag word byte by byte
to the peripheral word
Block end
Explanation
CP 523
)
H
EWA 4NEB 811 6044-02a