Setting The - Siemens SIMATIC S5 CP 523 Manual

Print Mode
Setting the page number (job number 20
Specify the page number in binary code in byte 1.
Execute form feed (job number 5000
If the "Output line feed" request 6000
Execute line feed (job number 6000
This job request generates a blank line. A subsequent "Execute form feed" request 5000
this request if it has not yet been serviced.
Clear message buffer (job number 7000
All print requests stored in the message buffer are deleted.
Print all messages (job number 8000
The message texts are printed as configured, with the message text number at the beginning of
the line.
Transfer parameter setting data (job number 90
On restart, the CP 523 accepts the data in DB 1 as you configured it on the memory submodule.
You can use this job request to change part of the parameter setting data on the CP 523. You can
change the data in parameter blocks 0, 2 and 7. The contents of the memory submodule remain
unchanged.
• Job number 9000
H
- Parameters for the serial interface
(changing the baud rate, for example)
• Job number 9020
H
- Parameters for the "XON" and "XOFF" protocols
• Job number 9070
Setting the Print mode with job number 9070
Note:
The data transferred to the CP with the "Transfer parameter setting data " request has priority
over the data stored on the memory submodule in DB 1. The parameter setting data on the
memory submodule is valid after power-up, provided it has not been overwritten by the user
program.
Illegal job orders in Print mode
If you write a job number into word 0 of the transfer memory other than the numbers listed
above, the CP flags "Illegal job request" (4X
request A001 , for example, is permissible in Communications mode but not in Print mode. In Print
H
mode, this request would result in error flag 4X
This error will also be flagged if you transfer illegal parameter setting data with "Transfer para-
meter setting data".
6-40
H
)
H
has not yet been serviced, it is cancelled by this request.
H
)
H
)
H
)
H
(parameter block 0 of DB 1 on the memory submodule)
(parameter block 2 of DB 1 on the memory submodule)
, (parameter block 7 of DB 1 on the memory submodule)
H
)
)
H
.
H
) in the status byte. The "Coordinate data transfer"
H
in the status byte.
H
CP 523
cancels
H
EWA 4NEB 811 6044-02a