Table of Contents
Advertisement
ET42202M-S-PD
L2+ Managed 20-port 100Base-FX/1000Base-X SFP + 4-port 10/100/1000Base-T or
100/1000Base-FX SFP Combo Optical Ethernet Switch with AC + DC inputs
3-5.2.3 ACL Status
The section describes how to shows the ACL status by different ACL users. Each row describes
the ACE that is defined. It is a conflict if a specific ACE is not applied to the hardware due to
hardware limitations. The maximum number of ACEs is 512 on each switch.
Web Interface
To display the ACL status in the web interface:
4. Click Monitor, Network, and then ACL status
5. If you want to auto-refresh the information then you need to evoke the "Auto-refresh".
6. Click "Refresh" to refresh the ACL Status
Figure 3-5.2.3: The ACL Rate Limiter Configuration
Parameter description:
User :
Indicates the ACL user.
Ingress Port :
Indicates the ingress port of the ACE. Possible values are:
All: The ACE will match any ingress port.
Port: The ACE will match a specific ingress port.
Frame Type :
Indicates the frame type of the ACE. Possible values are:
Any: The ACE will match any frame type.
EType: The ACE will match Ethernet Type frames. Note that an Ethernet Type based ACE will
not get matched by IP and ARP frames.
ARP: The ACE will match ARP/RARP frames.
IPv4: The ACE will match all IPv4 frames.
IPv4: The ACE will match all IPv4 frames.
IPv4/ICMP: The ACE will match IPv4 frames with ICMP protocol.
IPv4/UDP: The ACE will match IPv4 frames with UDP protocol.
IPv4/TCP: The ACE will match IPv4 frames with TCP protocol.
IPv4/Other: The ACE will match IPv4 frames, which are not ICMP / UDP / TCP.
IPv6: The ACE will match all IPv6 standard frames.
www.ot-systems.com
241
Ver.1.0
Advertisement
Table of Contents
