Lenovo ThinkStation P910 User Manual page 91

7. Position the flex module cover on the flex module. Ensure that the rail guides on the bottom of the flex
module cover engage the rails on the flex module. Then, push the cover to the front of the flex module
until it snaps into position.
Figure 38. Reinstalling the flex module cover
8. Connect the card reader cable to the USB 2.0 connector or card reader connector on the system
board. See "Parts on the system board" on page 7.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 130.
eSATA connector or IEEE 1394 connector
To install or replace an eSATA connector or IEEE 1394 connector in the flex module, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 59.
2. Slide the flex module out of the front of the computer. See "Device in an optical-drive bay" on page 65.
3. Lift the clip on the side of the flex module upward. Then, slide the flex module cover to the rear of
the flex module to remove the cover.
Figure 39. Removing the flex module cover
4. If you are replacing an eSATA connector or IEEE 1394 connector, do the following:
.
Chapter 7 Installing or replacing hardware
79