Lenovo ThinkStation P910 User Manual page 89

3. Lift the clip on the side of the flex module upward. Then, slide the flex module cover to the rear of
the flex module to remove the cover.
Figure 33. Removing the flex module cover
4. If you are replacing a card reader, do the following:
a. Disconnect the card reader cable from the system board. See "Parts on the system board" on page 7.
b. Pull the clip as shown to remove the card reader with the card reader retaining bracket out of the
flex module.
Figure 34. Removing the card reader in the flex module
c. Flex the four clips on the sides of the card reader retaining bracket to remove the card reader from
the bracket.
Figure 35. Removing the card reader from the card reader retaining bracket
.
Chapter 7 Installing or replacing hardware
77