Troubleshooting / Frequently Asked Questions - Silvercrest EDS SBB 850 B1 User Manual And Service Information

SilverCrest EDS SBB 850 B1

Troubleshooting / Frequently asked questions

 Display indicates "HHH"
Problem: A program was started although the automatic bread maker had not cooled down
enough since the last baking process.
Solution: Stop the programme and disconnect the mains plug. Let the automatic bread maker cool
down with its cover (2) open for 20-30 minutes.
 Programme does not start and display
jumps to programme 1
Problem: The automatic bread maker has not cooled down enough since the last baking process.
Solution: Let the automatic bread maker cool down with its cover (2) open for 20-30 minutes.
 Display indicates "EE0", "EE1" or "ELL" after programme starts
Solution: Switch off the automatic bread maker and disconnect the mains plug. Then insert the
mains plug again. If the error message is still displayed, please contact customer service.
 The dough hook (6) is stuck in the baking tin (7) after baking
Solution: Fill the baking tin (7) with hot water and turn the dough hook (6) so that the deposits can
dissolve.
 The dough hook (6) is stuck in the bread after baking
Solution: Remove the dough hook (6) with the dough hook remover (10).
 The motor turns, but the dough is not mixed
Solution: Check whether the baking tin (7) and dough hooks (6) are locked into place correctly.
 Automatic bread maker crushes fruit and nuts
Solution: Only add ingredients such as fruit and nuts to the dough when the beep sounds and
"ADD" is indicated on the display .
 Automatic bread maker does not work
Solution: Make sure that the mains plug is connected to the power supply and the power LED
lights up. Use the programme sequence to try to determine the current phase of the automatic
bread maker. Some programme steps are hard to recognise from the outside. Check whether the
button was pressed correctly.
18 - English