Mitsubishi Electric QD62 User Manual page 18

2 SYSTEM CONFIGURATIONS
Applicable CPU module
CPU type
C Controller module
2
2 - 2
CPU model
Q06CCPU-V
Q06CCPU-V-B
1 Limited within the range of I/O points for the CPU module.
2 Can be installed to any I/O slot of a base unit.
3 For the coincidence detection interrupt function, use the Basic model
QCPU of function version B or later.
4 Use the QD62 (E/D) whose serial No. (first five digits) is 09012 or later.
5 The coincidence detection interrupt function is not supported.
6 Connection of extension base units is not available with any safety
CPU.
REMARK
For use of a C Controller module, refer to the C Controller Module User's Manual.
(b) Mounting to a MELSECNET/H remote I/O station
The table below shows the network modules and base units applicable to
the QD62 (E/D) and quantities for each network module model.
Depending on the combination with other modules or the number of
mounted modules, power supply capacity may be insufficient.
Pay attention to the power supply capacity before mounting modules, and if
the power supply capacity is insufficient, change the combination of the
modules.
Applicable network No. of mountable
3
module
QJ72LP25-25
QJ72LP25G
QJ72LP25GE
QJ72BR15
1 Limited within the range of I/O points for the network module.
2 Can be installed to any I/O slot of a base unit.
3 The coincidence detection interrupt function is not supported.
REMARK
The Basic model QCPU or C Controller module cannot create the MELSECNET/H
remote I/O network.
1
No. of modules
Main base unit
Up to 64
Main base unit of
1
modules
remote I/O station
Up to 64
MELSEC-Q
2
Base unit
Extension base unit
: Applicable, : N/A
2
Base unit
Extension base unit of
remote I/O station
: Applicable, : N/A
2 - 2