Table of Contents
Advertisement
8 PROGRAMMING
Setting item
CH1 Present value
CH1 Latch count value
CH1 Sampling count value
CH1 Periodic PLS counter previous value
CH1 Periodic PLS counter present value
CH1 Sampling/periodic counter flag
CH1 Overflow detection flag
8 - 15
(b) Auto refresh settings (see Section 7.5)
Set the values as shown in the screen below. (Use channel 1.)
Set the device for storing the present value.
Set the device for storing the latch count value.
Set the device for storing the sampling count value when the
sampling counter function is used.
Set the device for storing the previous periodic pulse count
value when the periodic pulse counter function is used.
Set the device for storing the present periodic pulse count
value when the periodic pulse counter function is used.
This is not used.
Set the device for storing the overflow detection result when
the linear counter function is used.
(c) Writing the intelligent module parameters (see Section 7.3.3)
Write the intelligent module parameters to the programmable controller
CPU. This operation is performed using the intelligent module parameter
setting module selection screen.
Description
MELSEC-Q
Setting
W0
W2
W4
W6
W8
—
W10
8 - 15
Hide quick links:
Advertisement
Table of Contents
