Safety Information - Stromer ST2 Operating Manual

SAFETY INFORMATION

Please thoroughly read all of the warnings and
instructions in this operating manual before you
begin riding the S-pedelec. Please always store
these operating instructions near your S-pedelec,
so that they are accessible at any time.
Before the first ride, please be sure to read the
chapters "Before the first ride" and "Before ev-
ery ride"!
Should you hand your S-pedelec to third parties,
make sure to hand over these operating instruc-
tions with it. These instructions include symbols
that require your special attention. Whenever
these symbols are shown, there is a risk that the
problem described actually occurs! The area to
which the explicit warning applies is identified by
red lettering.
4 5
Note: This symbol provides you with infor-
mation about handling the product or the part
covered in the instruction manual and should be
read with attention.
Attention: This symbol warns of misuse
which could result in damaging the product or the
environment.
Danger: This symbol indicates a possible
risk of injury when the appropriate, required ac-
tions are not implemented or the respective pre-
cautionary measures are not taken.
Important screw joint: Here, you must
tighten with the exact torque. To find out the cor-
rect tightening torque, you can either look at the
bike part itself or in the table listing the tension
values, which is found on page 68. A torque
wrench must be used to apply the exact tighten-
ing torque value. If you don't have a torque
wrench, bring your bike to a Stromer shop for re-
pair! Parts that have been installed incorrectly
may fall off or break! This may result in severe
falls!
Modern pedelec technology is high-tech!
Working on it requires technical knowledge, ex-
perience and special tools! Do not work on your
pedelec by yourself! Take your pedelec to a spe-
cialist workshop when it is in need of repair,
maintenance or restoration!
Regularly check that all screw connections are
tight and all components are undamaged.