Safety Information Regarding The Charger; Charging The Battery - Stromer ST2 Operating Manual

Safety information regarding
the charger
Read the operating instructions for the char-
ger before beginning to charge the battery.
You can change the battery of your Stromer while
it is installed in your S-pedelec. However, you
can also remove the battery from the S-pedelec
and charge it in another place. It is particularly
advantageous to charge it in a warmer environ-
ment (room temperature) when it is cold outside,
in order to shorten the charging period. Avoid
charging processes below 0 °C or above 40 °C and
in tightly sealed spaces. The charging process is
automatically stopped at temperatures below 0 °C
or above 40 °C.
Please note that a sudden change of tempera-
ture from cold to warm can cause condensation
to build up in the charger. Avoid this by storing
the battery in the same place where it is charged.
Only use the charger supplied or a charger re-
leased by Stromer to avoid the risk of fire.
22 23
Use the charger in a dry room and don't cover it up
while it is in use. It could otherwise short circuit
or cause a fire.
Check the mains voltage before connecting the
charger! The voltage of the power source must
correspond to the information on the type plate
of the charger.
• Always pull the plug out of the socket before
cleaning the charger.
• The charger should be disconnected from the
mains once the charging process has been
completed.
For safety reasons, always place the charger
on a dry, non-flammable surface.
A defective battery should neither be
charged nor used any further. A battery can be-
come warm while charging. It must not get hot.
When the battery heats up strongly, immediately
terminate the charging process.
Never ride when the battery is not inserted.
The battery compartment can in this case not be
locked. This poses an additional risk of falls and
injuries.

Charging the battery

Always read the charger information first.
Charging the battery externally, outside
the S-pedelec
First connect the charger to the mains pug (LEDs
light up red and green) and then to the battery.
Hold the charging cable loosely in your hands and
bring it gradually closer to the socket of the battery.
The magnets will help you to position the plug
correctly.
The LEDs in the charger light up in orange and
green during the charging process.
The LEDs in the charger light up in green when
the battery has been fully charged. Separate the
battery/Stromer from the Stromer charger and
then the charger from the mains connector.
Charging the battery internally in the
S-pedelec
The connection for the charging cable is located
on the left side of the down tube, slightly below
the connection to the head tube.
Open the cover of the charging socket.
1. Connect the charger to the power mains. The
integrated LEDs light up in red and green.
2. Hold the charging cable loosely in your hands
and slowly move it near the socket of your