Before The First Ride - Stromer ST2 Operating Manual

Ensure that your child has learned and understood
safe and responsible handling of their S-pedelec
in the appropriate environment.
Do not let children who are unattended ride
the S-pedelec without first thoroughly instructing
them in how to use it! Explain to children the dan-
gers of using electrical devices.

BEFORE THE FIRST RIDE

Please thoroughly read all of the warnings and
instructions in this operating manual before you
begin riding the S-pedelec.
Please also consider the operating instructions of
the individual component manufacturer, which
are available on the Internet.
Your specialist Stromer dealer will be happy to an-
swer any further questions you have after reading
this manual. Ensure that the S pedelec is ready for
use and adjusted to fit your body. This includes:
• Setting the position and fixture of the seat and
handlebars
• Checking the assembly and settings of the
brakes
• Securing the wheels into the frame and forks
To ensure that you enjoy a safe and comfortable
riding position, please allow your Stromer dealer
to set up your handlebars and stem.
• Adjust the seat to a safe and comfortable posi-
tion for you (see page 48).
• Allow your Stromer dealer to set up the brakes so
that the brake levers are always within easy reach.
• Ensure that you know which lever operates
which brake.
Familiarize yourself with the new bicycle in
a protected area.
Modern braking systems can have signifi-
cantly stronger and different braking effects to the
brakes you are familiar with. Please get to know
the brakes on a safe piece of land before setting
off on your first ride with the bicycle!
Also remember that the effectiveness of brakes
can be dangerously different in wet conditions or
on slippery surfaces. Please take the possibility
of longer braking distances and slippery surfaces
into account when riding!
If rubber or plastic pedal covers have been
put on your pedelec, familiarize yourself with
their grip. When wet, rubber and plastic pedals
are very slippery!
Ensure that the wheels are securely fastened in
the frame and fork. Check the firm attachment of
the quick-release axles and all important fasten-
ing screws and nuts (see section "Screw connec-
tions").
If you hear rattling or other unusual noises during
operation, have your Stromer dealer determine the
cause and remove it before you continue riding.
Push the S-pedelec forwards while pulling the
brake lever. The back brake should completely pre-
vent the back wheel from moving, while the front
brake should lift the back wheel off the ground with
its braking effect. The bicycle's steering should not
rattle while braking or exhibit any play.
Please take an initial test ride in a safe place
where you can familiarize yourself with the new
brakes! Modern brakes have a very strong brak-
ing effect.
Check the air pressure in the tires. You will find
instructions as to the correct tire pressures on the
sides of the tires. Please adhere to the required
minimum and maximum pressure!
If you cannot find any recommended pressures,
2.5 bar is a suitable pressure for most tires.
Hint: As a general rule of thumb when you are
out on a ride, you can check the tire pressure by
doing the following: If you place your thumb on
a pumped up tire, you should not be able to sig-
nificantly change its shape by applying pressure.
Check the tires and rims. Scan them for any dam-
age, cracks or deformations, as well as embedded
particles, e.g. shards of glass or sharp stones.
If you should find any cuts, rips or holes, please
refrain from riding! First have your S-pedelec
checked by a specialist.