Safety Information - Stromer ST3 User Manual

SAFETY INFORMATION

Please thoroughly read all of the warnings and
instructions in this operating manual before you
begin riding the S-Pedelec. Please always store
these operating instructions near your S-Pedelec,
so that they are accessible at any time.
Before the first ride, please be sure to read the
chapters "Before the first ride" and "Before ev-
ery ride"!
Should you hand your S-Pedelec to third parties,
make sure to hand over these operating instruc-
tions with it. These instructions include symbols
that require your special attention. Whenever
these symbols are shown, there is a risk that the
problem described actually occurs! The area to
which the explicit warning applies is identified by
red lettering.
4 5
Note: This symbol provides you with infor-
mation about handling the product or the part
covered in the instruction manual and should be
read with attention.
Attention: This symbol warns of misuse
which could result in damaging the product or the
environment.
Danger: This symbol indicates a possible
risk of injury when the appropriate, required ac-
tions are not implemented or the respective pre-
cautionary measures are not taken.
Important screw joint: Here, you must
tighten with the exact torque. To find out the cor-
rect tightening torque, you can either look at the
bike part itself or in the table listing the tension
values, which is found on page 29. A torque
wrench must be used to apply the exact tighten-
ing torque value. If you don't have a torque
wrench, bring your bike to a Stromer shop for re-
pair! Parts that have been installed incorrectly
may fall off or break! This may result in severe
falls!
Modern S-Pedelec technology is high-tech!
Working on it requires technical knowledge, ex-
perience and special tools! Do not work on your
S-Pedelec by yourself! Take your S-Pedelec to a
specialist workshop when it is in need of repair,
maintenance or restoration!
Regularly check that all screw connections are
tight and all components are undamaged.
Snagging hazard
Moving and turning parts of your Stromer
may lead to danger during use, maintenance and
upkeep.
Protect yourself by not wearing loose clothes that
may get caught. During use, maintenance and up-
keep, stay away from turning parts (wheels, brake
discs, cassettes). Do not touch moving, sharp or
protruding parts (chains, pedals).