Removing The Battery; Inserting The Battery - Stromer ST2 Operating Manual

Storage at a battery charging level of 40-60%
is best suited to preserving your battery. Please
consider that this shortens the period after which
deep discharging is possible when compared to a
fully charged battery! The capacity of a battery de-
creases with age, even when it is well-maintained.
You should change a battery that has not been
used or recharged for a prolonged period before
you install it in your S-pedelec.
Permissible storage temperature range:
-20 – 60 °C
Permissible discharging temperature range:
-20 - 60 °C
Permissible charging temperature range: 0 – 50 °C

Removing the battery

Open the battery box with the appropriate key.
1.
Push the key into the lock applying gentle pres-
sure and turn it in a clockwise direction until the
battery box opens.
Pull out the battery.
The battery is very heavy, so take care not to drop
it. You could get injured and/or the battery might
get damaged.
2.

Inserting the battery

Place the battery into the battery box. Take care
that the connector points downwards and that the
lettering THIS SIDE UP is visible on top. Push the
battery downwards until it latches.
Close the battery box. Press with your flat hand
onto the flap until it latches with a soft click and
then pull the key out of the lock.
Never leave the key in the lock. You might get
injured by the protruding key or clothes might get
caught on it, which might lead to a fall.
Always pull the key out of the lock and keep it
at a safe place to ensure that it does not break
or get lost.