Brakes - Stromer ST2 Operating Manual

Mounting
1.
• Guide the wheel between the mounts from the
bottom. The hub has to slide into the groove
provided in the left mount. (1)
• The cable running from the motor must be lo-
cated under the chain stay.
• Ensure that the chain is correctly positioned on
the sprocket.
2.
• Insert the quick-release axle in to the mounts
and hub. Tighten it to 20 Nm. (2)
3.
28 29
• First, put the small plug (a) together and screw
it shut. Then, put the large plug (b) together
and screw it (3).
4.
• First, insert the thinner cable (a) in the cable
guide. Push it down until it clicks into place.
Then insert the larger cable (b) in the cable
guide. Also press this cable in until it clicks. (4)
5.
20 Nm
• Position cable and plug back in the starting
position. (5)
• Do not touch the brake disc or the wheel.
Make extra sure that the brake disks are
correctly located between the brake pads after re-
installation!
Tighten all screws with the prescribed fastening
torque (see "Torques" section). Failing to do so
could cause the screws to tear and components
to come apart.
• Check that the brake pads are aligned with the
brake surfaces.
• Test the brakes.
Read the instructions of the gear unit manufac-
turer to ensure correct and safe installation and
setting of derailleur systems.

Brakes

Your Stromer is equipped with a hydraulic disk
brake.
Brakes are vital to your safety on the bike.
You should therefore maintain them on a regular
basis. This requires specialist knowledge and spe-
cial tools. Leave all work on your S-pedelec to
your Stromer dealer! Work that is improperly car-
ried out endangers your safety on the S-pedelec!
Brake discs and brake pads are particularly
subject to wear. Please allow a specialist retailer
to check these key parts on a regular basis and
replace any worn parts if necessary.
Source: Shimano® techdocs