Gears; Inspection Plan - Stromer ST2 Operating Manual

Do not touch the brake disk while it is rotat-
ing or directly after braking. This could result in
injury or burns.
Safety instructions for hydraulic disk
brakes
Avoid permanently braking for longer peri-
ods, as can be the case during long, steep de-
scents. Otherwise this can allow vapor bubbles to
form and cause a complete failure in the braking
system. This could result in serious falls and in-
jury.
The brake lever must not be applied if the
S-pedelec is on its side or upside down. Otherwise
air bubbles can enter the hydraulic system which
could cause the brakes to fail. After transport-
ing the bicycle, check if the pressure point of the
brakes seems softer than it was before. Slowly ap-
ply the brakes several times. This allows the brak-
ing system to discharge any bubbles.
If the pressure point remains soft, please refrain
from riding. The Stromer dealer must bleed the
brake.
You can avoid this problem by applying the
brake lever before transport and then fixing it in
this position using a strap. This prevents any air
from entering the hydraulic system.
When you come to clean the braking system,
please first read the instructions provided by the
component manufacturer.
You can get more information about your
S-pedelec's brakes as well as cleaning and main-
tenance in the operating manual provided by your
manufacturer or on the manufacturer's website:
www.stromerbike.com/support

Gears

Gears are vital to your safety on the bike!
Please read the operating instructions supplied to
you by your manufacturer and familiarize yourself
with how to operate the S-pedelec and switch
gears before your first ride. Allow your Stromer
dealer to undertake any work on your bicycle's
gears! Work that is improperly carried out endan-
gers your safety on the S-pedelec!
Information regarding the gears of your
S-pedelec can be found in the manufacturer's in-
structions at www.stromerbike.com/support and
on their websites on the Internet

Inspection plan

Modern S-pedelec technology provides high
performance, but must be regularly maintained
by qualified persons. This requires specialist
knowledge and specialist tools. Leave the work on
your S-pedelec to your Stromer dealer!
Work that you can safely perform yourself is
highlighted in bold. To ensure that your bicycle
remains in a safe condition and fulfills the condi-
tions of the warranty, the following terms apply:
• Clean your S-pedelec after every ride and check
it for possible damage.
• Have inspections carried out by the Stromer
dealer.
• Check your S-pedelec every 300 – 500 km or
every three to six months.
• Check that all screws, nuts and quick release
axles are secure.
• Use a torque wrench to tighten screw joints!
• Clean and grease moving parts (excluding
brake surfaces) according to the manufacturer's
instructions.
• Have paintwork touched up.
• Ask a specialist retailer to replace any broken
and worn parts.
You can get more information about your bi-
cycle's parts as well as cleaning and maintenance
in the operating manual provided by your manu-
facturer or on the manufacturer's website:
www.stromerbike.com/support